Get Started

About ADAS & GO

We exist because post-collision safety systems don’t get a second chance to fail. ADAS & GO calibrates every vehicle to exact OEM standard — no shortcuts, no guesswork, no exceptions.

A vehicle raised on the alignment rack in an ADAS & GO calibration bay
Watch Who We Are and What We Do

See it for yourself

A closer look at how we work, who’s behind it, and why precision isn’t negotiable.

A member of the ADAS & GO team speaking to camera in the workshop
Two vehicles parked in the open calibration bays, with roller doors along both walls.
The equipment floor of the laboratory, with a white sports car parked at the far end.
The customer lounge, with framed prints above a green sofa and armchairs.
A white electric sedan on the alignment rack in front of the ADAS & GO wall logo.
A technician setting a calibration rig in front of a wall of pattern target boards.
A technician unrolling a large printed floor target across the laboratory floor.
A radar reflector mounted on its stand, positioned in front of a vehicle.
A technician positioning a calibration target at the front of a vehicle in the bay.
An electric SUV on the alignment rack with calibration targets clamped to its wheels.
A screen showing the guided ADAS software at the auxiliary tool positioning step.
A sedan raised on the rack with its hood open and diagnostic leads connected.
A white performance coupe with its hood open in the calibration laboratory.
A technician working at a laptop in the open door of a sports car.
A laptop on a rolling stand cabled into a vehicle during a programming session.
A technician seen through a side window, working on a laptop inside the vehicle.
A technician working in the open cabin of an electric SUV.
A technician photographing a wheel assembly on a phone to document the work.
A finished white sports car with two staff members reviewing the job beside it.
How We Started

A gap we couldn’t ignore

ADAS & GO started with a simple observation: as vehicles got smarter, the industry calibrating them didn’t keep up. Too many post-collision repairs were sending cars back on the road with safety systems that were never properly verified — cameras out of alignment, sensors uncalibrated, warnings silenced instead of fixed. We built ADAS & GO to close that gap, one vehicle at a time, with a process built around OEM procedure instead of shortcuts.

10Locations, 1 Standard
12k+Vehicles Serviced
99.7%Accuracy Rate
RivianCertified
What We Won’t Compromise On

Precision isn’t optional

OEM Procedure, Always

Every calibration follows manufacturer specification exactly — no aftermarket shortcuts, no “close enough.”

Full Documentation

Every job is recorded and verified, giving your shop a clean audit trail for insurance and compliance.

Consistent Across Every Location

Same training, same equipment, same standard — whether it’s Tampa or Marietta.

We Own the Outcome

If something goes wrong with a service we performed, we take the accountability and the liability. That’s not a policy exception — it’s the baseline.

We pick up and deliver every single vehicle.

Who’s Behind It

The people behind the standard

  • Michael Good

    CEO

  • Billy Russel

    COO

  • Photograph pending

    Alex Wickham

    CCO

  • Photograph pending

    Larry Kruguer

    CFO

  • Haley Good

    Executive Admin Assistant

  • Photograph pending

    Cathrine Weis

    Accounting

Certified & Compliant

Optimized to manufacturer standard

ADAS & GO holds active certifications across major OEMs, including Rivian, with procedures updated as manufacturer requirements evolve.

Ready to hand off the technology?

Tell us about the job and we’ll route it to the nearest location.

We typically respond within one business day.